Fascia and soffit repair in Tulsa.
Rotted fascia is the most common reason gutters pull away from Tulsa homes. Cracked soffit is how squirrels and wasps find their way into your attic. These are not cosmetic problems. They are structural failures on your roofline, and they get worse the longer they wait.
Q: When does fascia need to be replaced before new gutters go on?
Most homeowners do not think about fascia until their gutters start sagging. By that point, the wood has been rotting for months. It starts at the top edge where caulk failed and water got behind the paint, or at the bottom where the gutter overflowed repeatedly and dripped down the back of the board. The paint conceals it until the fascia is structurally compromised.
Soffit is the underside of the roof overhang. It closes the gap between the fascia and the wall. When it cracks or is left unrepaired after hail damage, it becomes an entry point. Squirrels get in. Wasps build nests. If the soffit is vented, those vents need to be properly screened to do their job without becoming a wildlife opening.
AE Roofing addresses fascia and soffit as part of the full roofline. When we are replacing gutters, doing a new roof, or handling storm restoration, the fascia and soffit get inspected as part of the scope. If they need work, we handle it in the same project.
Seven signs your roofline needs attention.
Gutters pulling away from the house
If gutters are sagging or separating from the roofline, the fascia behind the hangers is almost certainly rotted. New hangers in the same wood will not hold.
Paint peeling on the fascia board
Peeling paint that starts at the top edge or bottom lip of the fascia is a moisture signal. The wood behind the paint is wetter than it should be.
Dark staining or discoloration
Vertical stains or dark patches on the fascia or soffit indicate water has been running where it should not. Staining is the earliest visible sign of moisture damage.
Soft spots when probed
If you can press a screwdriver into the fascia without much resistance, the wood has rotted. This is the test roofers and gutter installers use on-site. We do it at every inspection.
Cracked or missing soffit panels
Cracked vinyl soffit, or gaps where a panel has shifted or blown out in a storm, are entry points for pests and moisture. Squirrels will find a gap that small.
Visible pest activity at the roofline
Wasps building at soffit vents, or evidence of animals entering at the roofline, indicate gaps in the soffit assembly. The pests come after the gaps, not before.
Hail impact damage after a storm
Aluminum soffit panels dent in hail. Vinyl soffit can crack. Both are covered under most storm claims when documented as part of the full property inspection.
Five steps from rotted roofline to a sealed finish.
Inspect the full roofline
We walk the entire perimeter, not just the section with visible damage. Fascia rot can travel along a run without showing obvious signs at every board. Soffit gets checked for cracks, gaps, and pest entry points.
Full perimeterIdentify repair vs. replace
Limited rot in one section can be repaired. Widespread rot or damage that runs into the rafter tails requires full replacement. We show you what we find and explain the recommendation before any work starts.
Honest assessmentRemove rotted material
Old fascia and damaged soffit come off completely. We inspect the rafter ends and sheathing behind them. Any rot that has spread into structural members gets addressed before new material goes on.
Clean removalInstall new material
New fascia goes in, primed on all sides. Soffit panels installed with proper venting where required. Painted or wrapped with aluminum coil where appropriate. Corners and returns detailed correctly.
Properly installedCoordinate with gutters
If gutters are being replaced, they go on after the fascia is solid. If existing gutters are going back up, we confirm they are properly supported before we leave.
Gutter-readyThree fascia materials. One right choice for your home.
Primed pine: Traditional fascia material. Takes paint well. The least expensive option. Requires proper priming on all four sides, including the back, to resist moisture. If you are painting the exterior anyway, pine is a reasonable choice.
PVC trim board: Does not rot. Does not absorb moisture. Holds paint for longer than wood. Slightly more expensive than pine but eliminates the primary failure mode of wood fascia. Our most commonly installed fascia material.
James Hardie trim: Fiber cement. The most durable option. Resists hail impact, moisture, and insects. Paint lasts 15 years. Used when the rest of the exterior is Hardie siding and visual consistency matters.
Soffit options are vinyl or aluminum, in vented or solid configurations. Vented soffit maintains attic airflow when the ridge is also vented. Solid soffit in the right location. We spec what is appropriate for your existing ventilation system.
What drives the cost of fascia and soffit work.
Linear footage and material choice are the primary variables. Most Tulsa homes need 80 to 200 linear feet of fascia depending on the perimeter and number of returns.
Structural damage to rafter tails adds cost. If the rot extended past the fascia into the structural framing, those tails need to be sistered or replaced before new fascia goes on. We find it during tear-off and show you before proceeding.
Storm-related fascia damage is typically covered under your homeowners claim. We document hail impacts and wind damage on fascia and soffit and include it in the storm inspection report. Adjusters who receive properly documented scopes approve more than those who receive a verbal report.
Fascia as part of the roofline, not an afterthought.
Gutter companies check fascia as a condition of doing the gutter work. They are not set up to replace it properly or to address what they find behind it. Roofing companies often treat fascia as outside their scope unless it is directly tied to a roof failure.
AE Roofing runs the full roofline. When we do your gutters, we replace the fascia if it needs it. When we do the siding, we coordinate the soffit installation so the returns line up. When we do the roof, we inspect the fascia as part of the standard scope.
No passing it off. No leaving a note that the fascia is a problem and moving on. One crew owns the outcome. That is the difference with a general contractor who does roofing rather than a roofing company that occasionally does construction.
Fascia and soffit work across Tulsa and surrounding cities:
Questions before
the repair.
Not on the list? Call us. A human picks up.
Ask us directly →Gutters stay on when the fascia is solid. Let us check yours.
The next storm
isn't waiting.
Whether your shingles are curling, your gutters are sagging, or you just want a second opinion before your insurer's deadline runs out, book the inspection. We don't charge for it, and we don't push for it.
(918) 978-2660Direct line · 7am – 9pm · 7 days