Siding installation and replacement in Tulsa.
Oklahoma weather tests siding hard. Hail dents it. Summer heat warps it. Ice backs up under it. When it is time to replace or repair, you want one crew that handles the full exterior, not a siding-only company that leaves you to coordinate with three other contractors.
Q: What siding materials does AE Roofing install in Tulsa?
Tulsa homes built between 1985 and 2005 are reaching the end of their original siding's lifespan. That means a lot of vinyl that is fading, cracking, and losing its seal. It also means wood siding with decades of paint and caulk built up over rotting substrate. Replacing it is not just cosmetic. Siding is the primary moisture barrier on your home's exterior. When it fails, water follows.
AE Roofing handles siding as part of its full exterior scope. That means when the siding comes off, we inspect the house wrap, the sheathing, and the framing behind it. Rot gets replaced. Gaps get air-sealed. New house wrap goes on before the first board does. We do not just cover up what was there.
We install James Hardie fiber cement throughout Tulsa, Broken Arrow, and Owasso. We also work with LP SmartSide for homes that want the warmth of wood without the maintenance. Vinyl at the right price point, stone veneer for accents, and color-match repairs when the damage is limited. Whatever your home needs, we scope it correctly and build it once.
Seven signs your siding needs to go.
Hail dents and impact marks
Aluminum and vinyl both dent from hail. James Hardie does not. If the whole envelope shows impact marks after a storm, replacement is usually the smarter financial move versus patching.
Warping, buckling, or cupping
Vinyl that warps in summer heat was either installed too tight or is at end of life. Buckling creates gaps where moisture enters. Once water is behind the siding, the sheathing is next.
Fading that paint cannot fix
Chalking and oxidation on vinyl is surface-level at first, then structural. If repainting is not holding, the substrate has degraded and color-coating will not save it.
Rotted boards or seams
Probe suspect wood siding with a screwdriver. If it sinks, the substrate is compromised. Rot spreads. One bad board in a wet wall can become four courses of damage by next spring.
Interior moisture or mold
Moisture stains on interior drywall near exterior walls point to siding failure. If water is getting past the envelope and through the sheathing, siding repair is urgent, not optional.
High heating and cooling bills
Deteriorated siding loses its air-sealing capacity. Combined with old house wrap or no house wrap, it adds real cost to every utility bill. New siding with proper wrap tightens the envelope significantly.
Visible gaps around windows and corners
Caulk and trim failures at windows, doors, and corners are entry points. If the gaps are widespread, spot-caulking is a temporary fix. A full replacement seals the entire envelope at once.
Five steps from failing siding to a sealed exterior.
Inspect the full envelope
We walk the entire exterior. We check siding condition, house wrap integrity, trim, window seals, and any substrate rot. You get a written scope before we discuss price.
Free inspectionSelect materials together
We walk through Hardie, LP SmartSide, vinyl, and stone veneer options. We show samples. We talk through the trade-offs for your specific home, neighborhood, and budget. No pressure to upgrade past what makes sense.
Material selectionRemove old siding completely
Old siding comes off. Substrate gets inspected. Rotted sheathing and framing gets replaced before anything else happens. New house wrap goes on with properly lapped seams. This step is what separates a real installation from a cover-up.
Clean removalInstall and detail
Every board, panel, and trim piece installed to manufacturer spec. Corners, windows, doors, and penetrations all get proper flashing and caulk. We do not leave gaps and call them expansion room.
3 to 7 daysWalk-through and warranty
We walk the finished job with you. Every concern gets addressed before we leave. Manufacturer warranty gets registered in your name. AE Roofing workmanship warranty in writing.
Lifetime workmanshipFour siding products. One honest conversation.
James Hardie fiber cement is the benchmark for Tulsa homes. It resists hail, holds paint for 15 years, and does not expand and contract with Oklahoma's temperature swings the way vinyl does. It is heavier and costs more to install. Worth it on most homes.
LP SmartSide is engineered wood with a resin treatment that resists moisture, rot, and insects. It machines like wood and takes paint like wood, but without the maintenance overhead. A strong middle-ground option for homeowners who want that texture without fiber cement pricing.
Vinyl siding at the right thickness, installed correctly with proper back-flashing, is a legitimate product. The issue is when it gets installed thin, over bad substrate, or with gaps at windows and doors. We use commercial-grade vinyl minimum. No builder-grade materials.
Stone veneer is an accent product, not a whole-home siding. We install manufactured stone veneer on gables, columns, bases, and feature walls. It transforms curb appeal and holds up in Oklahoma weather. We coordinate it with whatever field siding you choose.
What drives the price on a siding project.
Material choice is the biggest variable. Fiber cement costs more per square foot installed than vinyl. LP SmartSide sits between them. Stone veneer is priced as an accent, not by square footage.
Substrate condition is the second variable. If the sheathing is solid and the house wrap is intact, the install goes quickly. If we find rot behind the old siding, that material and labor gets added to the scope. We show you what we find before we replace it.
If the project is insurance-related, our documentation often covers more than homeowners expect. We scope the full damage and attend the adjuster meeting. We have seen projects that started as a partial repair become full replacements once the adjuster sees properly documented hail damage across the entire elevation.
Siding is not a side job. It is part of the whole exterior.
Siding-only companies finish the siding and leave. If the gutters need to come off and go back on, that is a separate contractor. If the fascia is rotted behind the gutters, that is another call. If the windows need re-flashing after the siding is installed, you are coordinating schedules between three crews and hoping the seams line up.
AE Roofing handles the entire exterior. Gutters, fascia and soffit, windows, and full storm restoration all run under the same contract. When siding comes off and we find a moisture problem at a window, we fix it. We do not leave it for someone else.
We are a licensed Oklahoma general contractor. Every crew member is on payroll. We do not subcontract your siding out to the lowest bidder and collect a margin. The people who quoted your job are the people who show up on day one.
Siding installation across Tulsa and surrounding cities:
Ready to talk siding? We scope the whole exterior.
The next storm
isn't waiting.
Whether your shingles are curling, your gutters are sagging, or you just want a second opinion before your insurer's deadline runs out, book the inspection. We don't charge for it, and we don't push for it.
(918) 978-2660Direct line · 7am – 9pm · 7 days